Note: Udemy FREE coupon codes are valid for maximum 1000 redemption only and might get redeemed in few hours. Look for "GET THIS DEAL" green button at the end of Description.
This post may have affiliate link & we may get small commission if you make a purchase.
![[Few Hours Left] Udemy Sitewide $9.99 – List of 1300 Popular Courses (By Ratings, Hours of Videos, Categories, Authors )](https://media.freebiesglobal.com/2020/12/Udemy9.99.png)
Requirements
- Eagle software for desining pcbs
- Proteus software for simulation
- MikroC for pic programming
- Program burner for your pic programmer, i use winpicpgm
- Some components that will be introduced in lecture 12
Description
Use this coupon (50PERCENTOFF1) to get the course for 10 DOLLARS while you can.
This course is about pcbs and programming microcontroller
This course is submitted for beginners in microcontroller and pcb designing field
By the end of this course you will be able to
- Learn how to design a circuit in eagle schematic layout
- Turn your circuit into a pcb through the board layout
- Master pcb making using iron on glossy paper method
- Design a JDM programmer
- Design and make a laser sensor project
- Learn to simulate an electronic circuit using proteus
- Learn to program your pic using microC
- Learn the basic concepts of c programming language
- Burn your programs on your pic using computer
- Design a lot of microcontroller projects (flash light, traffic light, temperature sensor and security system using keypads and lcds)
- How to interface leds, lcds, seven segmants, motors, motor drivers, relays, keypads and ADC projects
This course will take 6 hours to complete
It is sperated into two sections
- Pcb designing section
- Microcontroller section
