STM32 Embedded Systems with Mbed CE: Real Hardware Online

days
0
0
hours
0
0
minutes
0
0
seconds
0
0
FREE $19.99 GET THIS DEAL
STMDISCOUNT9

What you’ll learn
Compile and run Mbed CE C++ programs on a real STM32 through the LabsLand browser IDE.
Read active-low buttons and control LEDs using the lab pin table and the DigitalIn and DigitalOut APIs.
Use serial messages and ADC readings to debug and test a voltage warning controller.
Control RGB brightness and servo position with appropriate PWM periods and pulse widths.
Combine sensor logic, timing and manual overrides in a smart parking controller, then document its behavior.
Explain a basic IoT device?gateway?cloud architecture and identify the firmware, protocol and peer needed for a wireless link.
Record predictions, real observations and test results to explain embedded program behavior.

Affiliate Disclaimer
This post may have affiliate link & we may get small commission if you make a purchase
Freebies Global
Logo